Batboard

Hello!

I have a CC2+, with TOMI, RS232, 2 timers, 11 BIM's, 1 Dual RX, 2 Card cages, redundant power supplies, and a compact op position.

I can not read or write to the TOMI, and I think it is a cable issue.

The software goes through all the steps, and gets to "SETTING UP CEB" and hangs.

I need a good pinout for a CC2+ RS232 RJ-45 to DB-25 (or DB-9).

Also, any jumpers need to be set on the TOMI?

Thanks,

Brian
KE6IYC