Page 1 of 1
MCS2000- Programming accessory connector
Posted: Thu Aug 07, 2008 5:46 am
by arlojanis
Where is the place in CPS to program the accessory pins for I/O 3, 4, and 5 ? This is a MCS2000 high power.
Re: MCS2000- Programming accessory connector
Posted: Sat Feb 09, 2013 12:55 pm
by tazada
Any reply to this message? Is it possible to channel steer a MCS via these pins? PL/DPL logic?
Thanks
Re: MCS2000- Programming accessory connector
Posted: Wed Feb 20, 2013 7:52 pm
by motorola_otaku
Short answer: you cannot program the accessory pin functions on a MCS2000 or channel-steer with them.
Slightly-longer answer: You can add a jumper to get true active-low COR and all the other connections are present by default (RX audio, TX audio, and PTT) for use in repeater linking, if that's what you're after.