Batboard

I cant get my ss2000 into programming mode
i have tried keying the mike while holding down the save button and turning the unit on
is there something else im missing
i have did this before with my other units with no problem, this one seems to be a pain

Should get you in the ball park

http://www.fedsig.com/products/docs/install/255283.pdf

thanks, i appreciate that
i was already there and that didnt help so i went and tried a different control head
and that fixed the issue
the control head i am using wont allow you to program it however you can program
it with the other head and use the new head to run it

thanks again


ryan

Glad you got your head(s) on straight

dewy wrote:thanks, i appreciate that
i was already there and that didnt help so i went and tried a different control head
and that fixed the issue
the control head i am using wont allow you to program it however you can program
it with the other head and use the new head to run it

thanks again


ryan

If you read the Fed Sig configuration manual, there is a jumper inside the control head that disables user programming... Solder it back together and you'll be good to go