Page 1 of 1
GM300 mdf file change
Posted: Wed Oct 08, 2008 1:20 pm
by SD70MAC
I have an old GM300 8 channel and I want it to be a 16 channel. I looked at the edit to the MDF file as listed and I changed the 08 to 10. When I install the program on my old laptop when I read the rado it gives me an error WRONG MDF FILE. I am using v5.00.00 GM300 RSS and the hex edit is new to me. Where did I go wrong ?
Re: GM300 mdf file change
Posted: Wed Oct 08, 2008 3:29 pm
by Max-trac
Sounds like you did not do the checksum correction.
SD70MAC wrote:I have an old GM300 8 channel and I want it to be a 16 channel. I looked at the edit to the MDF file as listed and I changed the 08 to 10. When I install the program on my old laptop when I read the rado it gives me an error WRONG MDF FILE. I am using v5.00.00 GM300 RSS and the hex edit is new to me. Where did I go wrong ?