Batboard

When you make an All Call or a Private Call on the TRBOs the receiving units have an alert tone before the audio comes through. When you make a group call there is no tone, just audio coming out of the speaker. Is there a way in the CPS to enable this tone?

The only tone available on a group call is the channel free indication tone which is in the general settings tab under tones.

When checked it gives you the same tone at the end of a received transmission as when you are in a private call.

Blast... That's too bad. Ok, thank you for your help!

They actually do have Group Call receive tones that beep prior to transmission. Right in the CPS.

I'm looking in the CPS and not seeing it. Where would I find that?

Contacts->Digital->Call

right under where you put the call ID there is a check box...if you have NOT updated the Firmware and CPS you will NOT see this option.