Batboard

Good Afternoon Everyone,

So I will cut to the chase as usual.

I have an XTS5000 that has multiple systems on it.

I am using a 7.1 P25 system, and two Smartnet Type II systems.

I have the exact same programming in my personal XTS2500. I scan across all 3 systems. In the Display section of CPS, I have ID Display and Scan ID Display checked in both radios.

When I scan in my 2500 and another 5000 that I know, it will display IDs for both the P25 system, AND both Smartnet systems.

However, this one radio will only display P25 IDs.

Again, I have the ID Display and Scan ID Display checked.

Is there something I am missing?

FW in the radio will dictate if it will do analog ID display.

SG