Page 1 of 1
Motorola Crimp Tool
Posted: Mon Dec 01, 2008 7:03 am
by JD
What is the model number of the Motorola or Amp crimping tool for the 10 pin accessory jack on the CDM/ CM series radios ?
Re: Motorola Crimp Tool
Posted: Mon Dec 01, 2008 9:00 am
by 486dx4
If you are talking about the 20 pin accessory connector on the CDM series (not sure where the 10 pin is) then the AMP tool is # 91516-1. Its a lot of money for the tool - around $490. I just bought some leads with the pins pre crimped on one end with 4 connectors for $16 on "a famous online auction site...".
Re: Motorola Crimp Tool
Posted: Fri Dec 05, 2008 8:31 am
by wireless1939
You might also want to try the Molex Crimp Service Tool #63811-1000. I bought one a few years ago for around $35 as I remember, but I note it now sells for $48 at Jameco. This tool will crimp a variety of Molex style connectors. It takes a little practice to find the right position for the crimp you need but good if your only doing a few.
Re: Motorola Crimp Tool
Posted: Wed Dec 17, 2008 12:05 pm
by GmanX
Use a D-SUB crimp tool. They aren't that expensive and do a reasonably good job.