Batboard

Is there anyway to tell what firmware is in a single impres charger? I'd rather be able to have someone "read" it and let me know instead of paying for the bump if it's not needed.

Well you could always look at the bottom label, it has the version on it. But if you didn't buy it new, then it could have been bumped to something higher then what the label shows...


-Marc

other option is to hack in a display a'la batdude, but if your display firmware is current and the charger firmware is old the display might not light up

if anything it would be a good indicator whether the firmware was current or not

I didn't even think to check the sticker. Thanks.

What does a charger firmware bump run nowadays?