Page 1 of 1
Connecting Zetron model 19 to PM 1500
Posted: Tue Mar 03, 2009 5:46 pm
by clmassey
Need help with the 26 pin rear Accessory connector on PM 1500. I cant seem to find a COR.
Heres the model 19 connector pinout:
Pin 1 - 12v+ DC
Pin 2 - DC Gnd
Pin 3 - Discriminator Audio
Pin 4 - Shield Gnd
Pin 5 - Mic Audio
Pin 6 - Busy
Pin 7 - Mic PTT
Pin 8 - Decode/PL detect
Pin 9 - COR/CSQ Detect
Pin 10 - Ack/Flat TX Audio
Any help matching these to the correct pin on the PM 1500 is greatly appreciated.
Re: Connecting Zetron model 19 to PM 1500
Posted: Fri Mar 06, 2009 12:43 pm
by wavetar
I haven't seen a PM1500 yet, but if it's the same 26-pin accessory connector as the XTL series, then pin 13 should be "Chan_act"...channel activation or carrier detect. Not sure if it's programmable or not. You can see the pin out in this thread here:
http://batboard.batlabs.com/viewtopic.php?f=4&t=77498
Good luck,
Todd
Re: Connecting Zetron model 19 to PM 1500
Posted: Wed Mar 11, 2009 3:04 am
by Jim202
I guess you haven't checked your private email. I do have the pin out connections for the PM1500. The
manual I have doesn't show a 26 pin connector though. It is a DB25 pin connector along side the small
round GCAI connectors going to the control head. All the PM1500 radios I have seen are 100 watt mobiles
and as such don't have the funky 26 pin accessory connectors like the CDM radios have.
Provide me with a valid email address and I will send you the PDF file I made with the DB25 connector
info on the pin connections.
Jim
jimszal at hotmail dot com
clmassey wrote:Need help with the 26 pin rear Accessory connector on PM 1500. I cant seem to find a COR.
Heres the model 19 connector pinout:
Pin 1 - 12v+ DC
Pin 2 - DC Gnd
Pin 3 - Discriminator Audio
Pin 4 - Shield Gnd
Pin 5 - Mic Audio
Pin 6 - Busy
Pin 7 - Mic PTT
Pin 8 - Decode/PL detect
Pin 9 - COR/CSQ Detect
Pin 10 - Ack/Flat TX Audio
Any help matching these to the correct pin on the PM 1500 is greatly appreciated.
Re: Connecting Zetron model 19 to PM 1500
Posted: Sat Mar 14, 2009 3:33 am
by Jim202
I must have been asleep when I typed CDM radio. I meant to say the XTL mobiles.
Jim
clmassey wrote:Need help with the 26 pin rear Accessory connector on PM 1500. I cant seem to find a COR.
Heres the model 19 connector pinout:
Pin 1 - 12v+ DC
Pin 2 - DC Gnd
Pin 3 - Discriminator Audio
Pin 4 - Shield Gnd
Pin 5 - Mic Audio
Pin 6 - Busy
Pin 7 - Mic PTT
Pin 8 - Decode/PL detect
Pin 9 - COR/CSQ Detect
Pin 10 - Ack/Flat TX Audio
Any help matching these to the correct pin on the PM 1500 is greatly appreciated.
[/quote]