Batboard

Hi,
I am looking for a console to put in my 2001 tundra truck for my Astro Spectras. It has split bench seats. Any pointers towards a compatible console would be awesome.
Thanks
--Don

Try one of these manufacturers:

http://www.havis.com
http://www.troyproducts.com/products/consoles.htm
http://jottodesk.com/Comersus/store/com ... cIndex.asp

I already checked all of them. They dont make anything for the toyotas.

It's highly unlikely that you're going to find anything purpose-built for an '01 Tundra. '01 CV or Super Duty yes... Tundra not so much. You'll need to find a console that will fit (either a short console or one of the angled vertical types) and build your own mounting hardware. This will not be a "plug-and-play" exercise.

yah that is what I figured. I know that others here have tundras/tacomas & thought I'd ask. Jottodesk recommends one of their consoles that you can screw to the floor. Kinda nervous about doing that in a company vehicle altho he did let me drill the roof for antennas hmm.
--Don

I mounted my control heads on a flex shaft and it works great. I offroad alot and still pretty solid mount for the control heads mounted on it.See my post about 7 before this one under 03 tundra install.http://batboard.batlabs.com/viewtopic.php?f=8&t=83298

What you might consider doing is to fabricate a piece of matal to be contoured to the floor. Bolt this to the
bottom of the new console box. Then make a bracket to attach to the under side of the dash that secures
the front. This should hold the console in place at the front. Without seeing what you have to work with at
the back, can't help any further.

I have done this in a couple of installations. I also drill a hole or two in the contoured to fit bracket. Then
take a couple of short sheet metal screws that are only long enough to bite into the rug. this keeps the
bracket from sliding around, but doesn't put holes into the sheet metal of the vehicle body. When you pull
the short screws out, you cant even tell where they were in the rug after rubbing the area a couple of times.
If you don't have a rug and have the rubber type matting instead, your screwed.

Jim

theplague wrote:yah that is what I figured. I know that others here have tundras/tacomas & thought I'd ask. Jottodesk recommends one of their consoles that you can screw to the floor. Kinda nervous about doing that in a company vehicle altho he did let me drill the roof for antennas hmm.
--Don