Page 1 of 1
CM200 External Alarm
Posted: Sun Apr 12, 2009 8:27 pm
by escomm
CM200 programmed with pin 4 set to external alarm and high. Mobile receives the call and acknowledges it with the 2 beeps. First the pin would not give me any voltage at all. I fiddled with settings a bit to no avail. Changed it to COR and then I had 12V full time on pin 4 anytime the radio was powered on. Then I reprogrammed it to External Alarm and now I have 12V full time on pin 4.
Any ideas???
Re: CM200 External Alarm
Posted: Mon Apr 13, 2009 6:08 pm
by Al
Current firmware version?
Re: CM200 External Alarm
Posted: Mon Apr 13, 2009 7:28 pm
by escomm
i imagine (hope) it would be the most recent, i took delivery on these radios last week
as it stands now motorola is shipping me 2 more radios, should have them tomorrow, hope they work ok. when i talked to the post sales support group they said there were a few calls about this last week... hope it's not a bad batch
Re: CM200 External Alarm
Posted: Tue Apr 14, 2009 10:57 am
by escomm
2 new radios arrived today, with 4.x firmware in them, programmed exactly as the two above and they work beautifully. Gonna chalk this up to a defect in the firmware in 3.03.04