Batboard

Can someone point me to the thread on the settings in Hex Editor required for viewing codeplug info.

Thanks in advance.

Can you be more specific?

akardam wrote:Can you be more specific?

Since the search features are down, I was looking to view and possibly edit information, ex. freq range etc. in a codeplug and thought there was certain fields in the Hex Editor ex Base Convertor etc that had to be defined and set up to perform this procedure. I was hoping someone could recommend a starting setup in the Hex Editor fields to accomplish this.

Einstein wrote:

akardam wrote:Can you be more specific?

Since the search features are down, I was looking to view and possibly edit information, ex. freq range etc. in a codeplug and thought there was certain fields in the Hex Editor ex Base Convertor etc that had to be defined and set up to perform this procedure. I was hoping someone could recommend a starting setup in the Hex Editor fields to accomplish this.

More than likely, you will need to mod the RSS in order for it to accept changed bandsplits of a radio, not the codeplug.

What kind of radio are you talking about?

start from here:
http://batlabs.com/gm300.html
eulalio

Most codeplugs are encrypted, so all your going to see in a hex editor is a bunch of jibberish.

Hightower wrote:Most codeplugs are encrypted, so all your going to see in a hex editor is a bunch of jibberish.

yes, for commercial series,this is the rosetta stone:

http://batboard.batlabs.com/viewtopic.p ... 25#p371601

eulalio