Page 1 of 1
New Mic Wiring RMN-5068A
Posted: Sat Jul 25, 2009 7:28 pm
by Tron
Does anyone know right off hand if the above desk mic for Radius/Maxtrac, etc., has the Tx audio line switched w/the PTT switch or it is live all the time.
Tron
Re: New Mic Wiring RMN-5068A
Posted: Thu Aug 06, 2009 5:02 am
by RF_Burns
Dip switch 1 controls the mic audio. ON=PTT controls mic audio OFF = Mic is live all the time.
Re: New Mic Wiring RMN-5068A
Posted: Thu Aug 06, 2009 6:19 am
by Tron
Didn't know there were any switches inside of it. I'll have to open it up. Why can't /\/\ supply a schematic for it like they did in the past? I know, costs too much, etc...
Tron
Re: New Mic Wiring RMN-5068A
Posted: Thu Aug 06, 2009 7:07 am
by escomm
Tron wrote:Didn't know there were any switches inside of it. I'll have to open it up. Why can't /\/\ supply a schematic for it like they did in the past? I know, costs too much, etc...
I raised a stink about this and was told to go pound sand. The HMN3000s were field serviceable and an infinitely better mic than the RMN5068. IMHO the 5068s are crap.
Re: New Mic Wiring RMN-5068A
Posted: Thu Aug 06, 2009 12:30 pm
by Will
All the desk mics since the metal ones have very poor audio quality and acoustics.