Batboard

I'm trying to program an M1225 and whenever I open the F8 Scan settings screen I get: RUN TIME ERROR 13------TYPE MISMATCH and when you click OK the program closes completely.

Anybody know anything about this. I have tried 2 verisions of the software, the Win98 and the Win2000, both with the same error. The strange thing is I have programmed this radio before with no problems.

Anybody have a codeplug I could use to clone?? VHF 40 Watt 24 CH.

Any help appreciated!!!

Thanks, BJ

Have you changed computers since your last programming?

Jim

BigJim wrote:I'm trying to program an M1225 and whenever I open the F8 Scan settings screen I get: RUN TIME ERROR 13------TYPE MISMATCH and when you click OK the program closes completely.

Anybody know anything about this. I have tried 2 verisions of the software, the Win98 and the Win2000, both with the same error. The strange thing is I have programmed this radio before with no problems.

Anybody have a codeplug I could use to clone?? VHF 40 Watt 24 CH.

Any help appreciated!!!

Thanks, BJ

No, but I just loaded the software on another laptop..

UPDATE, Just loaded the same software on another computer (IBM 390E) and get the same error.

Just curious, are all 24 channels programmed and are you using alpha tags? The M1225 was crippled by its low memory capacity

No, only using 8 channels total. They are alpha tagged.

Well it isn't a memory issue in the radio

Very strange. When this started I had gone in and turned off the priority scan, no problems.. Added 4 more modes then went to edit the scan screen and bang, ERROR and have had the error ever since.

A friend sent me a codeplug for the same model and when I try to clone it in I get "Byte Mismatch" error. Gonna look at these codeplugs with a hex editor and try to find the differences..

Is there a way to blank out the M1225 and start over?

Feel free to chime in with any ideas.

Thanks to all!!

BJ

i had the same problem i had to update to software ver 4 and had no more problems for some reason ver 3 was not working on some of the newer models

I was using version 4 with win 2000 when I encountered the error. Haven't found the answer yet.

Thanks