Batboard

I've got a conventional P1225 UHF here, P94ZPC90A2AA here that is telling me something, but who knows what it is. I don't. Maybe someone out there has seen this.

Short POST tone, then a few seconds later it gives me 3 tones hi to lo, and then 3 tones lo to hi, followed by a single beep tone.

No rx on the freq programmed, and when I PTT it acts like an LTR radio......pulses on and off a few times and the warbles hi-lo at me till I release PTT.

Anyone?

I bet is has a Scholer-Johnson LTR aftermarket board installed. Look at the PCB under the front housing, is it red?

No, but that's what it is.....it sez SJI right onnit, OPT-1225 board. Thanks.......into the toilet......

You might not want to do that. That ltr board with there software will let you have many more conventional channels that what you would normally get.

http://www.batlabs.com/m1225.html

It tells about them at the bottom.