Page 1 of 1
Minitor IV constant squelch
Posted: Sat Nov 14, 2009 2:31 pm
by Andy2712
I got board today and took apart an old M4 (which is not nearly as easy as the M2's used to be). When I put it back together and turned in on all I get is a constant squelch. Anyone have any idea what I may have done? Thanks.
Andy
Re: Minitor IV constant squelch
Posted: Mon Nov 23, 2009 11:59 am
by Lake Effect
Due to the age of your post, maybe you already figured out the problem but, if not, I'll take a shot at it.
Just above the vibrator motor, there should be a surface mount NPN transistor. It is next to board marking of "TP1" The transistor is easily caught on the edge of the housing when inserting the pager into place. It gets pulled loose and you have constant open squelch as I recall. Another place for trouble is a chip resistor closer to the top at "TP5". It has been a while since I saw that one so I'm not certain of the problem it causes. Good luck.
L.E.