Batboard

Hello People!

I have two GTX Morotola M11UGD6CU1AN (Trunked, 800MHz, 15W) with E06 on the screen. Radio can be read, programmed, but error persists.

The RSS used the GTX / MAX638-RVN 4150 - R04.00.00

I tried to blank board with the GTX LAB (R01.01.00 - Restricted to FTR).

To initialize the standart RSS, F2, F8, says the board is black and I must load a valid codeplug, load a valid codeplug a M11UGD6CU1AN, choose the serial number, programming and E06 persists.

I need help!

Did they have this error before, or only after you tried to re-initialize them? If the radios came to you this way, it's possible the boards don't actually match the model# on the label of the chassis. "E06" means the firmware doesn't understand the codeplug of the radio. For instance, putting an LTR codeplug into a Privacy Plus GTX, or vice-versa. I have also seen this error when someone tries to put a SmartZone LCS codeplug into a GTX. A SmartNet codeplug works fine.

Hello

After much struggle, I have sucess to recover two GTX with E06.

Steps I used.

Do "Blank Board with RSS GTX LAB. I used the "Restricted to FTR" even.

Open the RSS GTX 2000 (RVN-4150 Version R03.03.00B)

Load a valid codeplug in to RSS, load with the same model (my GTX: M11UGD6CU1AN)

Back to main menu, use F2 (service menu), F6 (board replacement).

Enter the serial number, press F8 and F8. Wait ...

If you have luck, radio back to life.

Optional: If you want to update the codeplug, load the GTX RSS R04.00.00b, read and rewrite the radio.



Ah!!! I need a two RF module (MHW2821-1) someone would have that and I can sell at a low price?

Thanks to all!