Batboard

So I have the parts, and a codeplug, however it's from CPS 2.02.

The codeplug is good because I can look at it in CPS, but when I try to use the codeplug in one of the usual tools for doing the conversion I either get

"ERROR : This file is not a valid
archive."

or

"Error : Cannot read file"

Any thoughts? do I need an older codepulg to force?

grinthock wrote:So I have the parts, and a codeplug, however it's from CPS 2.02.

The codeplug is good because I can look at it in CPS, but when I try to use the codeplug in one of the usual tools for doing the conversion I either get

"ERROR : This file is not a valid
archive."

or

"Error : Cannot read file"

Any thoughts? do I need an older codepulg to force?

If you have the M3 just pull a s-record from it. I don't think you will be able to get lab to read/load the CPS CP.


Jim