Page 1 of 1
How to program NAC on xts3000 with CPS
Posted: Tue Jan 05, 2010 2:42 pm
by b917447
I'm using CPS to program my astro XTS3000,
Though im not sure where or how i set the NAC on a astro channel.
Can anyone assist?
Re: How to program NAC on xts3000 with CPS
Posted: Tue Jan 05, 2010 6:59 pm
by RKG
Conventional|Personality|Astro.
Re: How to program NAC on xts3000 with CPS
Posted: Wed Jan 06, 2010 1:53 pm
by b917447
Thanks for that.
I should be abel to work out the settings.
Also is there anyway to transmitt with no nac on p25 for say use on citizen band ?
Re: How to program NAC on xts3000 with CPS
Posted: Wed Jan 06, 2010 6:16 pm
by Tom in D.C.
No, you need a Network Access Code to make P25 work, so forget about operating
P25 without an NAC, and forget about 11 meters too, unless you were just kidding.
Re: How to program NAC on xts3000 with CPS
Posted: Wed Jan 06, 2010 6:24 pm
by resqguy911
Perhaps he is referring to Australian CB in 477MHz?
Re: How to program NAC on xts3000 with CPS
Posted: Wed Jan 06, 2010 7:21 pm
by Tom in D.C.
Which is why I said "11 meters," in case he was referring to UHF rather than 27 mHz.
Re: How to program NAC on xts3000 with CPS
Posted: Wed Jan 06, 2010 8:09 pm
by b917447
Ok, thansk for that.
Yes i did mean aust 477mhz which is ok to use p25 on.