Batboard

Did not know were to post this. Sorry if in the wrong place.

With RSS NLA would it sitll be posible or even worth it to have someone program my AS3 with ham freq's ?
Not to shure on wich way to go.
There are only 6 to 8 freq's in the ham band that is in my area and 5 repeters that I would needed programed.

Any advice.

Thanks

While RSS is no longer available, CPS software is. You can either buy the software from "M" & also get the rib & cables, or you could visit some of the 2-way shops in your town. In my experience they give a break to hams if they program ham freq's, because you aren't using ham freq's to make money. [dispatching trucks etc] Where do you live? Maybe someone living close by reading this could help you load up some ham freq's. GARY N4KVE

I live in Layton Utah. I would rather pay someone to do the programing. I have read M's EULA and the primer over at the main site and I just dont want to do it.
besides that knowing my luck I would brick the radio, so I will let the pros do it. Then I will know it will work.

There are plenty of members here who could help you out. Just post in the wanted section.

Sounds Good will do so. Thanks For all the Help

Jerry

If you want to catch the shipping both ways, I'll program your radio. PM me.