Batboard

Hello everybody, I have a GP 380 with a codeplug error and I can't recover it.

I have tried flashing upgrade with the most recent firmware.

I have modified my 13-pin cable : I have strapped pin 12 (boot control) on pin 7 (ground) and in this mode the GP 380 prints all pixels on the screen but the Waris lab upgrade tool always says me :

"error downloading bootcode", "radio not in bootstrap mode".

Is everybody understanding anything ? Do somebody have a idea to solve it ?

Thanks !

Your just trying to upgrade it to a new firmware, and not flash a codeplug?

to get the code plug error off all you need to do is get yourself a gp380 codeplug and write it to your radio. i hope you saved your tuning software before you started tinkering with it. if not you need to have it re-tuned.

@ dispatcher7586 : Excuse-me but I don't very understand what you mean. Could you explain please ?

@ rydzewski : I had no tuner software and was new in Motorola so I didn't know, I didn't save tuning data...

Do somebody knows where I can find it the correct codeplug ?

post the info on the stickers on the back of the radio. im sure i can get u a codeplug for it.

Try the group at this link - they work with the GP 380:

http://forum.motorola-radio-support.co. ... board=31.0

You can also find posts in this forum on how to force codeplugs into a radio. As far as a codeplug goes, any codeplug other than the one that was originally in the radio could be a problem. ALWAYS save the original codeplug, in multiple safe places, in case this happens.

Thank you two for your infos !

the back of the radio :

TANAPA : PMUD1579A
VER.NO:R05.06.03 (no possible so I think it's R03.06.00)
#1571
SERIAL NO : 749HDG5209 (end : 5271 for the other)

MODEL NO : AZH25KDH9AN6 (end : AA6 for the other)
SUPER TANAPA: PMUD1579A
CMII ID : 99FJ0443