Syntor 9000 low ban scan issue

The General forum is where users can discuss any topic regarding Motorola communications equipment - hardware, software, etc. There are also several focused forums on this board, so please take the time to ensure that your questions doesn't fall into one of those categories before posting here!

Moderator: Queue Moderator

Post Reply
parsoons
Posts: 6
Joined: Sat Jan 05, 2002 4:00 pm

Syntor 9000 low ban scan issue

Post by parsoons »

On my syntor 9000 low band it has developed a scan issue. The scn light is lit but you need to push the scan button off and then back on where it will scan for a few minutes and then stop again. But the control head scan light stays on. Any suggestions?
Top
Mike B
Posts: 907
Joined: Thu Sep 20, 2001 4:00 pm

Re: Syntor 9000 low ban scan issue

Post by Mike B »

Other than the scan button light, the control head doesn't indicate if the radio is scanning or not. The control head display, Rx BUSY light and possibly the PRI or NON-PRI lights only change when it finds an active Rx mode in the scan list.

If the scan stops on a priority mode and the the Rx PL/DPL doesn't match what is programmed, the scan will get stuck on this priority mode with no audio. However, the control head will display the priority mode it stopped on.

Why do you think it has stopped scanning? Is there any BUSY light activity?
Top
Post Reply

Return to “General Motorola Solutions & Legacy Radio Discussion”