Batboard

I know it needs to be aligned properly...but I just need a set of P1-P6 calibration data from an 800MHz VRM650 to get it to RX until I can track down a 2600. Codeplugs do not contain the data so sending one will not help. Thanks!

I'm sorry I didn't see your post last week when I was surfin here.

I could probably get you a list of settings but they tend to vary quite a bit from unit to unit. Also, are you running on a system with more than 1 frequency, cause that's the only time it comes into play. With the exception of testing and what not.

If you still need that data let me know.

I actually was able to hunt down the settings...all good now but thanks!