Maxtrac LS conversion problem
Posted: Mon Mar 22, 2010 11:12 am
Hi everyone,
I have 2 Maxtrac 800 mHz. conventional radios that I want to convert to LTR operations.
I blanked both logic boards and tried to initialize the boards with Maxtrac LS software as LTR boards, however I get an error message "92 - TX Emergency signalling sytem is missing". This pops up a few seconds after starting to initialize the boards. I am using a known good Maxtrac LS firmware chip. Anyone ever run into this before? Any Ideas?
I am using version 2.03.00b Maxtrac LS software. I do not have access to the latest version, 3.00.00.
Thanks
Jack Coupe
I have 2 Maxtrac 800 mHz. conventional radios that I want to convert to LTR operations.
I blanked both logic boards and tried to initialize the boards with Maxtrac LS software as LTR boards, however I get an error message "92 - TX Emergency signalling sytem is missing". This pops up a few seconds after starting to initialize the boards. I am using a known good Maxtrac LS firmware chip. Anyone ever run into this before? Any Ideas?
I am using version 2.03.00b Maxtrac LS software. I do not have access to the latest version, 3.00.00.
Thanks
Jack Coupe