Batboard

I need to extend a 4 wire E&M circuit over ethernet. I've ordered up the IPMUX-1E to do this install. I see a few of you out there have used this as well. Does anyone have specific instructions on the IPMUX on how to configure the 4 wire E&M? Time is of the essence and as soon as I get the devices, I'll need to deploy them. Thanks.

I just read the manual on CD that came with the device. You can download the manual and be prepared before it arrives.

http://www.bestdatasource.com/RAD/data_ ... manual.pdf

Yeah. Log into them, point them at each other on the Ethernet, and set them to 4-wire.

Make sure one unit's clocking is set to INTERNAL, and the other to ADAPTIVE. Enable OAM signaling on both ends.

Thats it