Page 1 of 1
xts3000 decodes MDC unit ids only in scan, no other time
Posted: Fri May 28, 2010 8:16 pm
by wazzzzzzzzup
xts3000 decodes MDC unit ids only in scan, no other time.
it would be nice if it would decode MDC when its stationary on a channel.
any ideas?
Re: xts3000 decodes MDC unit ids only in scan, no other time
Posted: Fri May 28, 2010 9:23 pm
by jmr061
Do you have emergency function(s) enabled? I found this same issue with the XTS2500 recently. I didn't have emergency enabled and it would only decode in scan. Added emergency and it decoded in non scan then.
Jason
Re: xts3000 decodes MDC unit ids only in scan, no other time
Posted: Sat May 29, 2010 4:53 am
by wazzzzzzzzup
is that emergency radio wide, or just emergency per channel?
Re: xts3000 decodes MDC unit ids only in scan, no other time
Posted: Sat May 29, 2010 5:27 am
by jmr061
In the main MDC section of the codeplug.
Jason