Batboard

Been playing with the programming, and not sure if I'm doing something wrong or it's just not capable. I am trying to 'sticky' an MPL on a channel so that if i select a PL on one channel, then switch to another and select a PL, the first channel stays where it was and doesn't follow the PL of the second channel. Or even if I could specify a default PL to use on a per-channel basis so that it would always be the PL I set it to unless I change it via MPL. I tried changing the dynamic/static setting in MPL settings but it didn't seem to make any difference.

TL/DR: I want different PLs on different channels via MPL.

Host R12.00.17
DSP R12.00.05

Did you ever figure out how to do this? I'm trying to do the same on my 2500.

Is it a case of the same personality being used on both channels and thus the MPL won't stay independent?