Batboard

Hello all,

I have a question about the PIN OUTS for the Saber Vehicle Charger Units. I have the lists from the model specific area, however I just want to confirm that:
I put 12V to 11 and 24? Also what is PIN 5 for?? Also PIN 1???? do I place that one to Ground????

JonGage

Below is a cut and paste from the model specific area.


SVA Connector Pinouts

Interface Connector

Pin Description

1 Self-test (gnd on power-up)
2,3 V-
5 High on squelch open
11,24 V+
20 Audio+
21 Audio-

Power

Red + Power
Black - Power
Yellow Ignition Sense (disables battery charger)
Green Headlight Sense (turns on panel lights in MVA)
LED Function

NOOOOOOOOOOOOOOOOOOOOOOOOOOO

You put NO power to the DB25!

Just the 4 pin molex.

otay, Just hook up the speaker to the DB25 right??

-JonGage

As you probably already know, the audio from the 5487 goes to a powered speaker, and the audio being fed to the speaker board is line level. You don't do anything with the DB25 connector except to plug the speaker unit into it. Anything the speaker unit needs is sent from the 5487 and vice-versa. I imagine you could, if absolutely necessary, pick off the audio and send it to an external amplifier. I have a diagram of the speaker circuit around here somewhere if you need it. Send me your snail mail address via PM and I'll send the diagram to you.

Regards,