Trbo repeater, no front LEDs without prog. cable
Posted: Sat Feb 26, 2011 12:00 pm
Hi All,
I have a VHF Trbo repeater that has no from LED's (except the Power LED) unless I plug in the programming cable with a computer connected. If I unplug the USB end from the computer, the LEDs go out, so it would seem its getting LED power from the USB +5V source. The computer doesn't even have to have the TBO CPS installed.
This happened sometime during setup and programming, but I'm not sure when... I was doing 12 repeaters and this was the first one. I'm not sure if I clicked on a parameter that causes this, but 6 others were cloned from it and they all are fine.
I can't find any parameter that is different from the rest. The repeater works fine otherwise.
Any ideas?
Thanks
I have a VHF Trbo repeater that has no from LED's (except the Power LED) unless I plug in the programming cable with a computer connected. If I unplug the USB end from the computer, the LEDs go out, so it would seem its getting LED power from the USB +5V source. The computer doesn't even have to have the TBO CPS installed.
This happened sometime during setup and programming, but I'm not sure when... I was doing 12 repeaters and this was the first one. I'm not sure if I clicked on a parameter that causes this, but 6 others were cloned from it and they all are fine.
I can't find any parameter that is different from the rest. The repeater works fine otherwise.
Any ideas?
Thanks