Batboard

XPR6550 403-470 Firmware 01.07.02

Programmed a channel for the analog side of a dual mode Quantar with the correct DPL's. When listening to the channel, and the P25 side of the Quantar transmits, nothing is heard. This is correct. However when the radio is in scan, apparently the radio ignores the DPL RX setting and P25 data noise comes through. Unmute Rule is set to: Std Unmute, Mute.

Anyone else experience this?

Marshall

Guessing your PL detect may be set to Disabled in the scan list? Try changing to Priority & Non Priority or Non Priority if you dont' have any priority members in the list

escomm wrote:Guessing your PL detect may be set to Disabled in the scan list?

Your guess is correct. Problem solved. Thank you Jeff!

Marshall