Page 1 of 1
Radius Sm120 uhf Hex Editing
Posted: Mon Mar 14, 2011 9:07 am
by Bill101
I can not find a step by step information for hex editing a Radius sm120 UHF radio to cover the 440 ham band, and I sure could use some Help!
Repeater Builder has some info for VHF but not UHF can someone Help me?
Thanks
Bill
Re: Radius Sm120 uhf Hex Editing
Posted: Thu Mar 17, 2011 4:19 am
by kcbooboo
If some VHF information is on Repeater-Builder, perhaps you should ask those folks.
Bob M.
Re: Radius Sm120 uhf Hex Editing
Posted: Thu Mar 17, 2011 1:45 pm
by hfd376
I would think the hex editing for the sm50 would work for the sm120. I can't remember if that info is on batlabs or repeater builder.com.
Re: Radius Sm120 uhf Hex Editing
Posted: Fri Mar 18, 2011 6:41 pm
by Bill101
Thanks Guys for the reply`s to my request.
hfd376 i havent seen anything here but , the other site has some info, on VHF but I cant figure out where the UHF part is located in the MDF file. I am not verry familiar with Hex Workshop, so for this "Dummy" it is hard to do.
I am sure there are some people here that could help if they wanted to.
Thanks Guys
Bill101