Batboard

I just installed a vhf mtr-3000 15 channel conventional analog base. All the channels that are simplex rx and tx fine. I can change the channels with no problem. When I try and tx on a channel setup to talk through a repeater I get no transmit only receive. Has anyone experienced this before.

I would check it with a service monitor to (1) verify it is on the correct input freq for the repeater, and (2) verify the correct PL is used.

Does not transmit works fine with channels that are in the simplex mode but if the rx and tx are different will not transmit.

That ain't right. If it's under warranty, I'd talk to your MSS/dealer about it.

Started a service ticket with Mother M. Emailed them my codeplug they are trying to figure it out. We had a second unit which did the exact same thing. Sounds like a new a firmware release will be coming out shortly.