Page 1 of 1
MCS2000 high power ignition sense question
Posted: Thu Apr 07, 2011 4:51 pm
by FIRE6115
I have a mcs2000 model 3 110w remote mount
I bought a ignition sense plug and it does not seem to work
Any ideas??
Re: MCS2000 high power ignition sense question
Posted: Fri Apr 08, 2011 5:00 am
by JeffFireRadio
Hello. Are you aware that the MCS2000 (and most other modern M mobiles) require a software setting to acknowlege your ignition sense desires in addition to a proper wiring configuration? If you're sure that you're wired correctly (power cable, ignition sense cable and proper pin positioning), I would start with the programming. I have three in my vehicle (two high power units) and have addressed this during their installation. Best wishes.
- Jeff
Re: MCS2000 high power ignition sense question
Posted: Sat Apr 09, 2011 7:04 am
by FIRE6115
No I did not know that but I will Check what field is it under in the CPS
Thanks
Re: MCS2000 high power ignition sense question
Posted: Sat Apr 09, 2011 10:13 pm
by MP 6.7
Radio Configuration, Radio Wide, Advanced tab, Ignition switch dropdown menu. Yours is most likely set to "blank" if the ignition sense wire does nothing.