HELP with XTS programming issue.
Posted: Mon Apr 18, 2011 5:55 pm
Hey All.
I have a problem.
I recently purchased a XTS2500 VHF radio from n7maq here on the board. It is a FPP model which has been the saving grace. I currently have CPS V14.00.00 and the radio was programmed by V15.00.00. My problem arises is that when I go into programming software, an error message pops up saying that I can't access the radio due to the radio being programmed by a newer software. Normally this wouldn't be an issue, except that I have found that I can't access the ability to change zones since there is no button on the radio set up to change zones. So I find this all out after FPP'ing all my channels into the radio and now I CAN'T access said zones.
What I am wondering is one of two things.
Is there anything I can do to allow me to access the radio (V15.00.00) with my CPS (V14.00.00) or is there a way to access, VIA FPP the setup to allow me to set a button or two to change Zones?
Sorry for the long winded question.
JJ
I have a problem.
I recently purchased a XTS2500 VHF radio from n7maq here on the board. It is a FPP model which has been the saving grace. I currently have CPS V14.00.00 and the radio was programmed by V15.00.00. My problem arises is that when I go into programming software, an error message pops up saying that I can't access the radio due to the radio being programmed by a newer software. Normally this wouldn't be an issue, except that I have found that I can't access the ability to change zones since there is no button on the radio set up to change zones. So I find this all out after FPP'ing all my channels into the radio and now I CAN'T access said zones.
What I am wondering is one of two things.
Is there anything I can do to allow me to access the radio (V15.00.00) with my CPS (V14.00.00) or is there a way to access, VIA FPP the setup to allow me to set a button or two to change Zones?
Sorry for the long winded question.
JJ