EX600 XLS internal mic replacement

The General forum is where users can discuss any topic regarding Motorola communications equipment - hardware, software, etc. There are also several focused forums on this board, so please take the time to ensure that your questions doesn't fall into one of those categories before posting here!

Moderator: Queue Moderator

Post Reply
pfd radio
Posts: 130
Joined: Thu May 05, 2005 6:46 pm

EX600 XLS internal mic replacement

Post by pfd radio »

I have an EX600 XLS and the audio from the internal mic sounds like you are on a motorboat.

Tried it with a remote Speaker/Mic and the audio was crystal clear.

I took the radio to a local Motorola shop and asked that they replace the internal mic. They said that it could go to the depot for $300 or they could get a refirb kit for $420 (Because the mic element is in the front case and cannot be replaced separately).

Is that true? If not is there an internal mic assembly if yes a part number would be great. Any suggestions are welcome.
35echo
Posts: 107
Joined: Sun Dec 02, 2007 8:07 pm

Re: EX600 XLS internal mic replacement

Post by 35echo »

PFD,

Your local shop is wrong.

The part number is 5013920A04 MICROPHONE MINI ELECTRET $4.10 list

Regards,

Allen
pfd radio
Posts: 130
Joined: Thu May 05, 2005 6:46 pm

Re: EX600 XLS internal mic replacement

Post by pfd radio »

Thanks Allen


I knew that something was wrong with that story.
User avatar
HLA
Posts: 2334
Joined: Mon Jul 11, 2005 8:15 pm
What radios do you own?: HT1550's, X9000's, CDM1550's

Re: EX600 XLS internal mic replacement

Post by HLA »

they are partially right but mostly wrong, you can get the mic separate like listed above but it is part of the front housing and comes with the housing kit but that kit I thought was around $50. if that's the case then it's worth it to get the housing kit and just make the radio look like new again at the same time. new mic, new speaker, new keypad, new flex connectors, new display glass
HLA
I never check PM's so don't bother, just email me.
I won't reply to a hotmail, gmail, aol or any other generic free address, if you want me to reply use a real address.
STOP ASKING ME FOR SOFTWARE OR FIRMWARE, I JUST FORWARD ALL OF THE REQUESTS TO THE MODERATORS
Batwings21
Posts: 930
Joined: Fri Jun 23, 2006 11:21 am

Re: EX600 XLS internal mic replacement

Post by Batwings21 »

A housing kit is really expensive, as it comes with the display and the controller board/keypad board. They have to be ordered either vhf or uhf also. There is a refurb kit for abt 50 that has all the plastic parts, but none of the electrical parts, you need to transfer those over. If it looks good, I'd just order a mic element. If the case is trashed, I'd get the refurb kit too since you will have it all apart to change the mic. So they weren't totally ripping you off, just mostly, they probably didn't even look to see if they could get the mic element.
Post Reply

Return to “General Motorola Solutions & Legacy Radio Discussion”