Batboard

Anyone know what kind of connector this is? It is threaded on the outside and about 1/2 inch in diameter.



Thanks!

The radio connector is just a standard threaded polarized M2 DIN (Male 2 pin DIN) bulkhead mount as far as the external portion goes. Except for the number of pins and diameter, it is very similar to the old style mobile microphone connectors on the control heads. Can't remember what the portion looked like inside the radio - it may have been standard or something proprietary made for MotherMoto. The power cable has a 2 pin threaded collar female DIN (F2 DIN) connector. They are available from several vendors like Digi-Key. You'll need to match up the diameter, metal or plastic body, shielded or unshielded, threaded, etc.

The originals used a metal body threaded collar connector, shielded (though the shield wasn't really used as such), and had either SJ jacket 2 conductor cable with braided shield, i.e., microphone/audio cable, or a 2 conductor 16 gauge unshielded SJ jacket cable. A lot of microphones and rack-mounted theater and roadie audio gear has these threaded DIN connectors on them, so the stuff is still available from numerous sources. The connectors are referred to by configurations such as F2 DIN for Female 2 pin DIN with other alphanumerics denoting diameter, threaded, shielded, yadda yadda yadda. Some of the older units had a small box with a glass fuse in the center of the cable length while the later stuff had the fuse in the plug on the source end.

Given all that.. I still haven't been able to locate a suitable conenctor, this is the closest I have come, but the threads appear to be different: http://www.bulgin.co.uk/PDFs/Cat83_sect ... series.pdf

This is for a Saber-X battery if it makes a difference.

I am not sure but this might work..

http://cgi.ebay.com/2PIN-FEMALE-METAL-M ... _500wt_689 .

Do you have any more of the battery housings, I have been looking for one for a long time?

I hope this helps...

Bill

That is the connector. NSPD, make sure the diameter is correct - they are available in different sizes. In the event that particular one isn't the right diameter, see if you can get the mfr name off the connector and hit the internet. Amphenol was one of the manufacturers.

Thanks for the info guys... that was the correct size plug. I ordered one and we shall see how it works.

Well, FYI to anyone taking on a similar project, that connector is not it. It does appear that if I grind it down, it will work though for the time being.