Batboard

Hi Group: I have a question about Minitor III pagers. I recently picked one up and purchased all required hardware
to program it. I am using a windows 98 machine running the program under true DOS. I am recieving (model number error)
It shows the correct model number and serial number is showing a question number for one of the digits and it does not show
any other programming information in the pager.
I have tired v 3.05 and 3.14 and am getting the same error.
Can anyone shed any light to what the problem may be?
Thanks in advance,
Bill

I'd try programming it with Windows PPS. I had the same problem with my Minitor III's. Nothing showed in DOS software, but Windows software showed everything just fine.

I'm using version 2.1.0 for Minitor III & IV that I got off of MOL a while back.