Thanks for the help and posts
Posted: Fri Jul 01, 2011 5:50 pm
Thanks to the posts on this and the 800mhz Maxtrac thread, I successfully converted a 35W Privacy Plus Maxtrac to a 16 channel conventional with apparently all functions of the 16 pin connector working and programmable.
I had a bunch of 16-pin UHF Maxtrac 300's on the shelf and I robbed the firmware chip from one of them.
Took me a couple of tried to figure out what model family I needed, finally found the "Maxtrac with accessories" entry and away it went.
Lots of guys ask questions and lurk....I just wanted to say thanks to all the wizards.
Best Regards,
Greg Carttar
I had a bunch of 16-pin UHF Maxtrac 300's on the shelf and I robbed the firmware chip from one of them.
Took me a couple of tried to figure out what model family I needed, finally found the "Maxtrac with accessories" entry and away it went.
Lots of guys ask questions and lurk....I just wanted to say thanks to all the wizards.
Best Regards,
Greg Carttar