HELP! NO RX AUDIO ON XTS3000??
Posted: Sat Sep 24, 2011 12:26 am
SO a recently acquired XTS3000 M3 radio that was reprogrammed to our channel config is not playing rx audio.
For instance on all the simplex conventional/analog freqs, the XTS300's red light just blinks which indicates that it is picking up some traffic but no audio. However, when I push the squelch button, the rx audio is played through the speaker and all works fine. OR if select an simplex freq and transmit on it, i'm able to hear immediate responses to me on that freq but after a few minutes, no rx audio unless i press the squelch button.
Specs on radio is Firmware 07.71.00, DSP N08.03.03, Flash 540008-000000-7
FIY, the rx and tx freqs and pl tones are the same. Also, all the conventional/repeated channels and P-25 channels tx and rx perfectly, it's just the simplex rx that is not working...any ideas??
ALSO, on the same radio, if radio lock is selected, the field to enter the power-on password stays gray and you can't input a password???
For instance on all the simplex conventional/analog freqs, the XTS300's red light just blinks which indicates that it is picking up some traffic but no audio. However, when I push the squelch button, the rx audio is played through the speaker and all works fine. OR if select an simplex freq and transmit on it, i'm able to hear immediate responses to me on that freq but after a few minutes, no rx audio unless i press the squelch button.
Specs on radio is Firmware 07.71.00, DSP N08.03.03, Flash 540008-000000-7
FIY, the rx and tx freqs and pl tones are the same. Also, all the conventional/repeated channels and P-25 channels tx and rx perfectly, it's just the simplex rx that is not working...any ideas??
ALSO, on the same radio, if radio lock is selected, the field to enter the power-on password stays gray and you can't input a password???