Batboard

Hello All-
I tried searching, but I can't find anything on this. Does anything need to be done in an xts5000 to set a Rx only channel to narrowband? I see the Tx Opt Transmit Dev setting for transmitting, but nothing for receiving and this setting is not enabled on Rx only channels.

Thanks for any help!

Once you set the TX dev to 2.5KHz the RX is also automatically set to 12.5KHz Channels automatically.

mike m wrote:Once you set the TX dev to 2.5KHz the RX is also automatically set to 12.5KHz Channels automatically.

Correct, set the RX and TX freqs and set the TX Dev to 2.5khz, then set that channel/mode to RX only.

Thanks guys. On a Rx only personality, the Tx Dev field is not enabled (greyed out). What I have been doing is making the personality Rx & Tx, change the Tx Dev to 2.5 and then make the personality back to Rx only.