Batboard

Well, I finally got a second to take a picture of my new truck's setup. I'm missing a plate for the console...don't judge . I finally got rid of my Stratus (http://batboard.batlabs.com/viewtopic.php?f=8&t=94535)


Equipment:
Motorola XTL-2500
Uniden BCD996XT
Uniden BCD996T
Ram Mount console, switches.
Whelen Traffic director for the traffic director in the back.
Whelen Slimlighter for front.
Some Sirennet.com cheap lights for the alley.
Garmin GPS Receiver
Antennas are EMs from WISCOMM: EMFLX-M10001 - Poly Spring VHF/UHF BB Quarter-Wave Roof Mount 108-520 MHz Antenna - ShopWiscomm - Communication Solutions


Yes, I drilled. GPS isn't hooked up yet by the visible serial cable in a few shots

Console:


Close up:


Dark Shot:


Antennas (missing the GPS antenna for the scanners):

Looks awesome!

It is hard to tell in your pictures, do you have the electronic 4wd switch or the floor shifter?

I am looking for a console but I have the floor shifter.

wnyevs wrote:Looks awesome!

It is hard to tell in your pictures, do you have the electronic 4wd switch or the floor shifter?

I am looking for a console but I have the floor shifter.

I do not have the floor shifter but you can move the console back far enough it should work. I believe they have designed this for a floor shifter as well. Check out their website to be sure.

Love the XTL radio! Plan on getting me one one day

tuckerm:
A standard width Havis will just about sit center of the mid seat area with the floor shifter, it may be just a tad bit right, but hardly noticable. Use the seat brackets with the track, then you can position the console as far left as possible. Test fitted on 2011 Silverado HD.

Updated my truck and added the BCD536HP with a GPS antenna to my truck.