Page 1 of 1
Does the Motorola P110 6ch have scan capability?
Posted: Mon Nov 21, 2011 6:44 pm
by kotaguchi
Its been a while I programmed the P110 so my question is does the 6ch model have scan capability?
Thanks in advance.
Ko
Re: Does the Motorola P110 6ch have scan capability?
Posted: Tue Nov 22, 2011 4:09 pm
by kt2728
I dont think so, you would have to convert it to a gp300. if it has not been made tamper resistant.
Re: Does the Motorola P110 6ch have scan capability?
Posted: Thu Nov 24, 2011 1:41 pm
by HLA
if it can then it will take up one of the channels but your best bet will be to convert it to a 16ch gp300
Re: Does the Motorola P110 6ch have scan capability?
Posted: Sat Dec 24, 2011 2:51 pm
by rjd
Yes, I just did it to one today. If you used the sixteen channel conversion "Alternate Method 2" from
here:
http://www.batlabs.com/gp300.html , then you are 90% there. While hacking the P110.mdf file,
look at the third byte after the byte that indicates the number of channels. This byte should be a 0x63.
Change this to a 0x67. Don't forget to correct for the checksum by subtracting four from some other byte.
With the new MDF file, RSS will allow you to select a "scan" type channel. In my MDF file, there are two
entries for P44QLC20B2. I had to modify both entries.