Batboard

Hello I hope someone can help me out. I pick up this radio
motorola mts2000 800mhz mod 3 flashport/smartzone ht but that is missing the controller board

Model # H01UCH6PW1BN

I want to switch it from 800mhz to 900mhz I need to know what controller board to get so that it will be on 900mhz? and where can I buy the controller board and the cost?

If you can help me contact me off the list

Thanks in advanced

73

miguel-ad4y

ad4y wrote:Hello I hope someone can help me out. I pick up this radio
motorola mts2000 800mhz mod 3 flashport/smartzone ht but that is missing the controller board

Model # H01UCH6PW1BN

I want to switch it from 800mhz to 900mhz I need to know what controller board to get so that it will be on 900mhz? and where can I buy the controller board and the cost?

If you can help me contact me off the list

Thanks in advanced

73

miguel-ad4y

For that model you can not replace just the controller and be on 900Mhz. You would also need to replace the RF board.
Might as well just purchase a 900mhz MTS.

Yes, I was told that also yesterday, I know I can buy one, but I would like to do this proyect, so I have to get a 900mhz RF Board and Controller Board, but I haven't seen that many or if I get a DOA radio that the boards are good that will work out too.

Else I have to sell this one that I got missing the controller board and find a similar one for 900mhz

Thanks for the input

73

miguel-ad4y

The only value in the parts you have now is the full-keypad front. With that you could take a plain model 1 MTX9000 and upgrade it to a full model 3 radio with a model 3 s-record or codeplug and the appropriate lab software.

Hello, Motorola_otaku

that sounds interesting, but I do not know how to do this you suggested, meaning I would need instructions on how to do this step by step, I can do the front face replacement but the forcing of a codeplug I would need help with that and I have to go to a friend that has the lab software so that I am able to do this.

Thanks for the input

Miguel

motorola_otaku wrote:The only value in the parts you have now is the full-keypad front. With that you could take a plain model 1 MTX9000 and upgrade it to a full model 3 radio with a model 3 s-record or codeplug and the appropriate lab software.

While you can force a B7 codeplug into a B3 radio, the B3 controller will not support the front display full keypad features. The best you can accomplish, is a B3 controller board will support a top display B4 setup. GARY N4KVE

Before u go off force feeding that MTS2000 FLASHCODED CONTROL BOARD,...
u might want to check if it is "TOOLPROOF"...

Yeah,,,,,, I did not see anyone mention that!!!!

Toolproofing only applies to MTS controllers. MTX controller boards were never toolproofed and can be labbed any ol' way to Sunday, aside from the B3 front control limitation that N4KVE pointed out.