Batboard

Richard Collier

Check Ebay I just picked up one with the sensor too.

Richard Collier

Thank you very much for the information, will look into that!

Richard Collier

Is that also the case with a XTS5000?

Richard Collier

Fans run 24/7 is there a fix to this. I thought they only come on when the PA gets warm. I shut the station down and turn it back on and the fans do the same thing. Pa in not warm not sure what to do.

Richard Collier

OK. I just wanted to listen to Camp Pendelton military police and fire and some live range comms. The rest of the radio is for ham use. DEC HEX Mode Alpha Tag Description Tag 31001 7919 D MCP PMO Provost Marshal Military 31101 797d D MCP PMO Tac1 Provost Marshal MP Tac 1 Military 31102 797e D MCP PM...

Richard Collier

I have a range 1 uhf XTL5000. I was trying to program the local military stuff in but not really sure where the control channels should go.Do they go into the OBT control channels or the OBT Astro control channels and do you have to program the RX and TX or just the control channels.http://www.radio...

Richard Collier

Main starting battery sitting at 12.86 volts.this morning.

Richard Collier

Found it!!!!! while doing my wiring I by mistake removed a wire leading to the 800 XTL5000 radio, I have 3 5000's in my Tundra. and it would had been the hot wire from the control head. I will know for sure in the morning. Batteries are charged by driving and a 100watt solar panel on the camper shel...

Richard Collier

Heads programmed 1 and 2 and so in the soft ware. Batteries and cables are so clean you can eat off of them.not recommended,radio is programmed right,I have not measured power drain will try to do today. Batteries have been load tested last week never had a single problem with them or the vehicle el...

Richard Collier

Every wire from the main radio and from the control heads is going to a Blue Seas fuse block which is powered only when the ignition is on. Everything should be dead no power at all when the ignition is off, confirmed with a volt meter.

Richard Collier

I have had a XTL5000 for a few years now and love this thing never had a problem starting my truck. I just added a second control head and noted my main battery dies over night. I have it set up where red wires are powered all the time like the manual states, the yellow wire is ignition switch on fo...

Richard Collier

Is there anyone who works on and repairs control heads, I am thinking my O5 head needs new picofuse??? I did use this on a dual head set up and the head is dead.

Richard Collier

I have a control head coming in today on a 380-470 radio that is set up for dual head operation. I should be able to just use a head off of that radio and check it out. Any one have a picture of the fuses on the head inside so I know what I am looking for.

Richard Collier

Starting to lean towards a control head problem. I know the second head worked but now it shows no sign of life. I even plugged the radio into the second head buy itself and it is not powering on. So we will see as this saga continues for the quest of a dual head radio.

Richard Collier

54C208-001844-7 is my flash code. I do not think the radio is Vmode as defined in the software.

Richard Collier

Yep I thought of that too.

Richard Collier

I want to run a dual head set up in my Tundra. I know both heads work they have been checked. Problem is I can not get the second head to power on. I have doubled checked the programming of the heads in the radio wide page. everything is set by the book but for the life of me it will not power on. A...

Richard Collier

Is there any way to make the fans come on at a lower temperature? Any adjustments anywhere? These are the 2 fans on the PA itself.

Richard Collier

Looking for someone who repair a 100w vhf amp that was fed a little to much input power by mistake.

Richard Collier

Motorola TLD2692A I know it is VHF what is the range and power output.

Richard Collier

What is the part number for a 125watt amp power supply for a Quantar. In other words the power supply .

Richard Collier

OK cool I guess this can hook up to a Quantar repeater without the junction box.

Richard Collier

Is there programming software for this item? Not requesting software! Just asking if there is. If there is what in the part number from Motorola?

Richard Collier

Ok one cap came off the other did not, even with a impact screw driver. So I drilled that one out and remade the cable ends with Amphenol N connectors. How do I get pictures to load!

Richard Collier

Thought about a vice and a Hammer screw driver, needs some parts from Mouser first.

Richard Collier

I tried getting the cover off, pretty hard at the moment. Will try again this weekend.

Richard Collier

I thought of that, I just might have to do that since the maker of the connector is no help to the little guys. Can not believe they will not sell just 2 connectors. I tried their dealers they sell to and they are out of stock.

Richard Collier

Still looking for some love here. I know some duplexer GOD knows a source for them Please help!!!!!

Richard Collier

No I have not. I did call Delta and they offered to sell me 500ea min order. How nice of them. Kinda sucks they can not just sell 2 or 3 of them. Thought that was on the greedy side. But still looking.

Richard Collier

RFS Model 0185417U02 duplexer I broke one of the right angle male/female N connector center pins. This part also has the RG142 cable I can do the cabling stuff I just need a source for this special connector. It is a Delta RF part 1105034 N001-002 I already have a call into Delta. If you look up the...

Richard Collier

Yes I have but not seen the info I need.

Richard Collier

Looking for a wiring diagram for the 2 front phone type jacks on the front of the Quantar control panel. Any pfd that I can download and look at. One shows a speaker and the other a hand set. What type of hand set or model number is used? Trying to set up a small remote with just a speaker and mike ...

Richard Collier

Got it working. Just wanted Air horn,Pa and exradio.

Richard Collier

Here is the flash code.50D288-801C84-1
Host sw R205005
DSP sw R195001
UCM sw R000000 not sure where to look for the control head stuff.

Richard Collier

Yes I did, I did the buttons the same as it is listed on the dek unit itself. Not really interested in the siren so to speak but just want the Air horn, Pa and Xradio to work. I do not even get the dek's night lights to light up when the radio is turned on.

Richard Collier

Still looking for some help or ideas.

Richard Collier

AS said I have a VHF XTL5000 with the 05 head remote mount. I do have a NIB Astro siren and cable and the Dek. Yellow round plug goes to the yellow on back of the control head, and the smaller one looks like a mike connector going to the dek. I have enabled everything I can think of in the software,...

Richard Collier

Thanks I do have the 03 head.

Richard Collier

As stated above, can the same cable from a non astro siren package say from a regular Spectra radio be used with the XLT 5000 radio? I have the Astro siren system NIB but no cable. Or is there a certain cable needed for it to work. All I really need is the PA and external radio function to work. And...

Richard Collier

Have done that in my XTS5000R 800 radio.

Richard Collier

Thank you for the response. It gives me some idea of what to expect while programming my radio.

Richard Collier

How many zones can you put into a Xtl5000 and how many channels per zone? This being on a say 800 trunked system. Or even analog system, say zone 1 what is the max channels you can do in a zone?

Richard Collier

NICE AND CLEAN.

Richard Collier

Then I would guess the users habbits and location even if use as a scanner. having just taken system administrator workshop class, it is VERY interesting to understand how it all comes together. The long and the short of it is the system is very powerful and also keeps detailed records of everything...

Richard Collier

I would assume that would include a so called ghost radio which would be one that only receives?

Richard Collier

Interesting on how this stuff works. It seems like the radio will transmit anyway but for a short time just to find the system. I thank both of you for the time to answer my question. Kinda cool has this stuff works.

Richard Collier

Just say one does program a radio on a trunked system, How do you know if the radio affiliates with said system. Is there a way to tell other than your radio being turned into a brick. Does the radio show a display beeps,flashing leds??? I am just asking and please do not read anything into this. Ju...

Richard Collier

Funny just did that, I thought it had taken before but it did not. Good to go Thank you for taking the time.

Richard Collier

Yep the eye glasses pop up view only field. I must be missing something.

Richard Collier

I have been trying to program new control channels in to my xts 5000 -700/800 meg radio and for the life of me I can not change them. Am I missing something in the programming, It will do Analog just fine. here is a list of the features of the radio. Any help would be great. 589008-101687-0 Decoding...

Search found 181 matches