try this link
http://www.geocities.com/mikeht220/nameplate.html

I run a communications center with 40 RPTA radio circuits. The phone company will not allow you to put anything on the lines. If you do, anytime the circuit goes bad they are going to say its your equipment causing the problem. When you lose a circuit you'll know right away because you wont be able ...

I don't know of any that will let you try it. There are many, many, many hours f work to set up a CAD system. Every street in your jurisdication broken down by block, all available units, all grid sectors, runnining orders for the grid sectors, all your call types etc. Then to make it work well all ...

Can someone supply me or direct me to the correct cabling for the Motorola T1500A duplexer. Also the tuning instruction would be helpfull. Bough on off the bay. Tuned it but I'm losing 30watts on the TX side. Evryone on the bay has diffent cabling configurations.

Thanks
Moto

My Saber III when in mode scanstops on all transmissions on freq even though they are not the right PL. Triple checked each channel has tx and rx pl's. As soon as you hit mode scan they stop on everything. No pl symbol in window when scanning.

also backlight out any ideas?

I need the pin outs for the jumpers in a mx-350s with 6 pl reeds.
Thanks

Yes I replaced the white plastic and blackrubber. the white plastic I'm sure is not upside down because it clibs into the radio frame., and it can only go one way. It seems when both parts are put together there is not enough room for the ptt plastic part to move. If i put the plastic piece in by it ...

I have an mx350. Trying to replace black PTT cover. I inserted the white plastic piece inside the black rubber cover along with the thin rubber membrane. Once I put it into then side of the radio I cannot get it to pt. It seems like its to close to the radio. I have the white pice in the right way ...