Hello,

So I have a strange error that just started appearing at all 3 of our Quantar simulcast sites when reconfiguring them for simulcast. "WL CTRL SIMULCAST 1PPS 188 SWARE INVALID LAUNCH TIME". Everything works and transmits when we turn off the simulcast, but obviously, the audio is totally ...

Ok I have 2 sites currently connect via v.24 , Quantar to Quantar. we are using p25 only, no analog.

(quantar v.24 Area1/Ch1) -- (v.24 cisco router) --(Internet) -- (v.24 cisco router) -- (v.24 quantar - Area2/Ch2)

I need to add 2 DIU3000s to each site so we can have a phone patch.(for the phone ...

WB audio works fine, this is happening on 3 different quantars, Ive even tried swapping WIB's with no luck. Even went as far as changing the transformer jumpers on the WIB's. Again the strange part is that when i put the units in TX wireline alignment mode i can hear the audio when keying and ...

Sorry I should have mentioned my wildcard setup too. (i'm running on no sleep)
wildcard input 1 set to low, table 1 is input aux 1 active then key from wl else wait 100 then dekey from wl

Wireline cards configured for 4 wire/half duplex

wiring is E signal(PTT) to telco pin 11(AUX 1),GND to telco 7 ...

I'm running into the same issue except i'm only using the internal controllers on repeat. sounds fine in the alignment screen. i'm running back to back between 2 quantars for simulcast over a E&M circuit. when a radio keys up the repeater keys and just hear dead air on the other repeater.
Wireline ...

Hey Everyone,

Ok so I got 3 XTL5000 VHF radios two are 50 watt M20KSS9PW1AN / 540201-001004-6 and the other is 110 watt M20KTS9PW1AN / 589288-801484-1.

The 110 has a working UCM and carrier with no issues, i use it on a daily basis.
The other 2 are new and i put a new carrier and UCMin them and i ...