i have a set of reeds on 118.8 a k1020a and a tln8381 also you said the m2 range do you need that exact pl tone

my gm 300 manual doesn't have the board layout and schematic for the hln8070D logic board i was wondering if anyone might know which manual might have it mine is6880902z32-a and if any one could copy the schematic and board layout and email it to me would be greatly appreciated thanks bob

quote from the tk 730 manual "if you use a remote kit the ext spkr output from the accessory connector ( 6pin) on the rear of the control head is 5 watt 4 ohm" use pins 5 and 6

my manual shows the brn/org wire to be the pl output from the origional pl board but the tone out from the comspec board should go to point "p" have done this numerous times and has worked

i have a p1225 that has a bad microprocessor clock crystal, y401. the manual doesn't give a part number as it is not field serviceable. was wondering if anyone might have a part number for this. it is a 7.9488 mhz xtal and is the same as the xtal in the sp-50

I was wondering if anyone has used the spreadsheet for programming the mostar radio it is kinda vague i can copy the prom to a eprom but how do i inset new info any help would be appreciated thx

I have a gr500 repeater with a zr340 interconnect can I program the zr345 for 2 pl tones or do i have to use a model 48 or something else? thx

recently came across having to replace some 48 pin smd's. which hot air device do you use? thanks bob

thanks for the help to all. by entering the service menu and exiting, all is ok thanks again bob

tried that but lost the image of the corrupt radio and you need that to clone over the top i have used hex editor to change the number of channels in a gm300 so thought that i could edit the codeplug s/n and rewrite to the radio cannot find the revised cp in the archive file to retrieve bob

I lost power to a maxtrac while in the service mode. It now gives me a low tone upon power up which I think is a corrupt code plug I have a codeplug for a maxtrac but has a different serial number. Can I use a hex editor to change the serial number of the good codeplug change the checksum and write ...