Batboard

I finally got a PLN7737B HHCH for my open face XTVA. I have it all hooked up on the bench. Tha radio sas REMOTE on the display but none of the HHCH controls work except PTT. The Mic works also. The buttons on the radio still function in remote. The radio is rev 7.71.06 dsp n08.03.05 flash 599008-041E00-2 Am I missing something easy?

Chris
N9LLO

XTS 3000 or XTS 5000? Also, I know a lot of the menu commands will not work with the HHCH (i.e. FPP, etc)

It is an xts3000

Will the HHCH even work with the open face XTVA? I am getting data on rj45 pin 2 and busy on rj45 pin 3 with every keypush. I programmed a side and top HHCH button for monitor and it works. PTT works(another data word on the HHCH) The top 6 buttons and vol, mode do nothing. So some work and some dont but all send data when prressed.
I already tried the processor initilization.

Any help appreciated.

Chris
N9LLO

I'll have to defer to others here who have used an XTS3000 with the XTVA. I heard with others who have tried with an XTS 5000 that the one main control that didn't work was FPP, but there might be others.

I should also mention this radio was hacked from a model II to a model III and still has a model II model number inside. I may have to try to put it back to a model II if I can find the original s record. Either that or figure out how to change the model number in the current s record to see if it is siome wierd hacking problem.

Chris

It is probably missing all the hhch data within the code plug. I have corrected several that are missing this. It's not fun.

Jason

I think it might be easier if I start out with a clean s record and change the serial number to match. What I have is an XTS3000 m3 RDH H09RDH9PW7BN. Any help appreciated.

Chris
N9LLO@aol.com