Users may not create topics, posts, or private messages containing or relating to the following material (especially pertaining to Motorola copyrighted software, unless you want Motorola to come along and shut this site down):

  • Listing for sale or trade of, or links to sites offering for sale or trade of, or giving away, Radio
    Service Software (RSS) or Customer Programming Software (CPS)
  • Profanity, pornography, defamation, or slanderous remarks directed towards any individual or entity
  • Commercial advertising (except in the Batboard Vendors forum, as approved by the Admin/Mod Staff)
  • Any other items which may be deemed as offensive

If any topics, posts, or private messages containing or relating to the aforementioned material are brought to the attention of the Admin/Mod Staff, they will be deleted.

Additional FAQ items appear here in Forum Rules. Please review them for posting guidelines and further clarification.

HT1250 Repair Question

The General forum is where users can discuss any topic regarding Motorola communications equipment - hardware, software, etc. There are also several focused forums on this board, so please take the time to ensure that your questions doesn't fall into one of those categories before posting here!

Moderator: Queue Moderator

medic712
New User
Posts: 3
Joined: Thu Apr 11, 2013 10:21 am

HT1250 Repair Question

Postby medic712 » Tue Mar 04, 2014 11:40 am

I'm trying to replace the battery connector on my HT1250...can anyone tell me how to do this without destroying the radio? Thanks

Al
Posts: 1045
Joined: Tue Sep 04, 2001 4:00 pm

Re: HT1250 Repair Question

Postby Al » Tue Mar 04, 2014 8:18 pm

I'm not trying to be facetious, but if you spend $2-3000 on hot air rework equipment the job's a breeze. Without the equipment, well, let's say it's very iffy whether you'll destroy the pads on the PCB or not, since the battery connection 'block' is an SMT device with the solder pads underneath the block.

Lake Effect
Posts: 311
Joined: Tue Dec 06, 2005 9:47 am

Re: HT1250 Repair Question

Postby Lake Effect » Wed Mar 05, 2014 5:22 am

If this is a personal radio and you have the soldering skills (nothing personal, I don't know what your skill level is) I can tell you how to do it. I have done it to my radio and it works just fine. If you have the replacement connector already, you will see on the bottom that each contact is held in by a small crimp. If you lift the end, the individual contact will slide out. On your radio, if you lift the bottom end of the block you can slide the block off the contacts. Then it is a matter of removing and replacing each bad contact one at a time. Then slide the block back in place. Done.

L.E.


Return to “General Motorola Solutions & Legacy Radio Discussion”

Who is online

Users browsing this forum: No registered users and 1 guest