Users may not create topics, posts, or private messages containing or relating to the following material (especially pertaining to Motorola copyrighted software, unless you want Motorola to come along and shut this site down):
If any topics, posts, or private messages containing or relating to the aforementioned material are brought to the attention of the Admin/Mod Staff, they will be deleted.
Additional FAQ items appear here in Forum Rules. Please review them for posting guidelines and further clarification.
- Listing for sale or trade of, or links to sites offering for sale or trade of, or giving away, Radio
Service Software (RSS) or Customer Programming Software (CPS) - Profanity, pornography, defamation, or slanderous remarks directed towards any individual or entity
- Commercial advertising (except in the Batboard Vendors forum, as approved by the Admin/Mod Staff)
- Any other items which may be deemed as offensive
If any topics, posts, or private messages containing or relating to the aforementioned material are brought to the attention of the Admin/Mod Staff, they will be deleted.
Additional FAQ items appear here in Forum Rules. Please review them for posting guidelines and further clarification.
BPR40 resets to default programming
Moderator: Queue Moderator
BPR40 resets to default programming
I have seen two Mag One BPR40's reset to default programming while being used in the field. Have any others seen this? Was it caused by low voltage from a bad switch or battery?
"The world runs on radio."
Re: BPR40 resets to default programming
Factory reset is a "feature" built into the firmware on the BPR40 according to the service manual. You press and hold both the PTT and lower programmable button then powerup the radio. A good key chirp tone signals completion of the reset. I've had it happen to a customer after his kids played with the radio.
Re: BPR40 resets to default programming
Oh wait a minute.... "Service Manual" is mentioned... Where, oh where, did you get a service manual for the MAG ONE bpr40? Please, oh please, tell me... it's not available from the big "M"...
Re: BPR40 resets to default programming
A stuck bottom button along with an inadvertent PTT press at power on will cause this. What? You can't d/l the manual from MOL anymore?
Return to “General Motorola Solutions & Legacy Radio Discussion”
Who is online
Users browsing this forum: No registered users and 1 guest